New low price! USA Made Glassware!
Our favorite and most functional attachment to the VB11 Pen.
See your vapor as it is being generated by the heater. The easiest way to take a flavorful and dense vapor hit from a pen.
Easy to load- Just pull the glass off and scoop the heater directly into your extracts. No threads to get dirty.
Connect the glass piece to the heater base being extra careful not to rip the O-rings or break the glass. It's best to push on and take off the glass with a twisting motion. Assemble with the VB logo toward you (The carb hole away from you). The battery should have its button also facing you. Push the button on the battery with your thumb, while holding your forefinger over the hole in the glass as shown:
Mini Viper is intended to be used with or without covering the hole. If the internal vent gets clogged, the pen will still make vapor.
Clear the internal vent periodically by pulling hard after heating the heater thoroughly. Holding the button down while inverting the pen for about 5 seconds and then provide suction from your mouth until you feel the airflow pop open. Ask us if this is not understandable. :)
Made with quality Simax glass in the U.S.A.
Comes with one extra replacement ceramic core "nail heater." Heaters are expendable and are best purchased as backups. Our recommended ceramic core heater is here (Same as supplied with this unit)
Check out the older style wick nail heater which is more delicate but hits quicker and soaks up oil better.
Click here for the color version.
Click here for the glass only of the clear version (Requires base and heater to operate)
Read our blog entry about the Mini Viper at vaporbrothers.blogspot.com
** Because of the unique nature of hand blown glass, your Mini Viper may vary slightly from the one shown in the image.
Check out this rundown by Vapor Rae at our sister site Vaporwarehouse.com